Eastbourne Driveway Quotes

Home / Imprinted concrete driveways

Imprinted concrete driveways in Eastbourne

Concrete stamped to look like stone or brick, then sealed.

Imprinted (pattern imprinted) concrete is poured over a sub-base, coloured, pressed with a pattern and sealed. It gives a block or stone look in a single slab, with no joints for weeds.

Imprinted concrete driveway, cross-sectionLayers from top: sealer, patterned concrete about 100 mm with steel mesh or fibres, Type 1 sub-base 100 to 150 mm, ground. Water runs off the surface. Rain runs off the surface, so it needs falls and a drainColoured, stamped and sealedtop 5 mmConcrete slab with meshabout 100 mmType 1 sub-base100 to 150 mmGround
Imprinted concrete driveway, cross-section. Expansion joints are cut across the slab to control cracking. It is not permeable, so it needs a linear channel drain at the boundary. Typical build-up only. Your installer will confirm the specification for your site.

Things to know

  • It is not permeable, so it needs a channel drain and soakaway at the boundary
  • Movement joints are needed to control cracking; ask where they will go
  • The sealer needs renewing every few years, more often in strong sun and salty air
  • Repairs are hard to match, unlike block paving

Rough cost

Per m², supplied and laid£55 to £95
Time on site2 to 4 days

Breaking out an old drive, drainage and a dropped kerb add to this. See the cost guide.

Common questions

Does imprinted concrete crack?

Hairline cracks can happen; good joints and a solid base keep them to a minimum.

How often does it need resealing?

Usually every 2 to 5 years.

Get a free driveway quote

Takes a minute. One vetted Eastbourne installer gets in touch to arrange a free site visit.

Phone or email needed so the installer can reach you. Free, no obligation.

Ready for a price?

Tell us about your driveway and one vetted Eastbourne installer will arrange a free visit.

Request a free quote